Anycubic PLA @4Max Pro 2.0

Anycubic · PLA · by prusa-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Inheritance

*common_4max*

→

*PLA_4max*

→

Anycubic PLA @4Max Pro 2.0

Settings

Basic information

Material variant: PLA inherited
Vendor: Anycubic overridden
Diameter (mm): 1.75 inherited
Density (g/cm³): 1.24 inherited

Print temperature

Nozzle (initial layer) (°C): 215 overridden
was 210 (inherited)
Nozzle (other layers) (°C): 207 overridden
was 205 (inherited)

Cooling

Fan minimum (%): 80 inherited
Fan maximum (%): 100 inherited
Disable fan for first N layers: 1 inherited
Full fan if layer below (sec): 30 inherited
Slow down if layer below (sec): 15 inherited
Min speed when slowed (mm/s): 10 inherited

Flow

Flow ratio: 1 inherited
Max volumetric speed (mm³/s): 0 inherited

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	60 inherited	60 inherited

Other settings

bridge fan speed: 100 inherited
compatible printers condition: printer_model=="4MAXPRO20" inherited
cooling: 1 inherited
fan always on: 1 inherited
full fan speed layer: 5 inherited

Raw resolved JSON

{
  "cooling": [
    "1"
  ],
  "fan_always_on": [
    "1"
  ],
  "fan_max_speed": [
    "100"
  ],
  "fan_min_speed": [
    "80"
  ],
  "filament_type": [
    "PLA"
  ],
  "hot_plate_temp": [
    "60"
  ],
  "bridge_fan_speed": [
    "100"
  ],
  "filament_density": [
    "1.24"
  ],
  "filament_diameter": [
    "1.75"
  ],
  "nozzle_temperature": [
    "207"
  ],
  "filament_flow_ratio": [
    "1"
  ],
  "slow_down_min_speed": [
    "10"
  ],
  "full_fan_speed_layer": [
    "5"
  ],
  "slow_down_layer_time": [
    "15"
  ],
  "fan_cooling_layer_time": [
    "30"
  ],
  "close_fan_the_first_x_layers": [
    "1"
  ],
  "hot_plate_temp_initial_layer": [
    "60"
  ],
  "compatible_printers_condition": [
    "printer_model==\"4MAXPRO20\""
  ],
  "filament_max_volumetric_speed": [
    "0"
  ],
  "nozzle_temperature_initial_layer": [
    "215"
  ],
  "filament_vendor": [
    "Anycubic"
  ],
  "name": "Anycubic PLA @4Max Pro 2.0",
  "filament_settings_id": [
    "Anycubic PLA @4Max Pro 2.0"
  ],
  "type": "filament"
}

Version history

View full history with diffs →

v1 created 2026-05-19 05:17