Jessie PLA @lulzbot

Printed Solid · PLA · by flsun-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Inherited from this (1)

Generic PLA @lulzbot

Settings

Basic information

Material variant: PLA overridden
Vendor: Printed Solid overridden
Diameter (mm): 2.85 overridden
Density (g/cm³): 1.24 overridden
Cost (/kg): 27 overridden

Print temperature

Nozzle (initial layer) (°C): 220 overridden
Nozzle (other layers) (°C): 220 overridden

Cooling

Fan minimum (%): 80 overridden
Fan maximum (%): 100 overridden
Disable fan for first N layers: 3 overridden
Full fan if layer below (sec): 60 overridden
Slow down if layer below (sec): 10 overridden
Min speed when slowed (mm/s): 10 overridden

Flow

Flow ratio: 1 overridden

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	60 overridden	60 overridden

Other settings

bridge fan speed: 100 overridden
cooling: 1 overridden
end filament gcode: ; Filament-specific end gcode ;END gcode for filament overridden
fan always on: 1 overridden
filament colour: #29B2B2 overridden
renamed from: PrintedSolid Jesse PLA @lulzbot overridden
start filament gcode: ; Filament gcode overridden

Raw resolved JSON

{
  "cooling": [
    "1"
  ],
  "renamed_from": [
    "PrintedSolid Jesse PLA @lulzbot"
  ],
  "fan_always_on": [
    "1"
  ],
  "fan_max_speed": [
    "100"
  ],
  "fan_min_speed": [
    "80"
  ],
  "filament_cost": [
    "27"
  ],
  "filament_type": [
    "PLA"
  ],
  "hot_plate_temp": [
    "60"
  ],
  "filament_colour": [
    "#29B2B2"
  ],
  "filament_vendor": [
    "Printed Solid"
  ],
  "bridge_fan_speed": [
    "100"
  ],
  "filament_density": [
    "1.24"
  ],
  "filament_diameter": [
    "2.85"
  ],
  "end_filament_gcode": [
    "; Filament-specific end gcode \n;END gcode for filament\n"
  ],
  "nozzle_temperature": [
    "220"
  ],
  "filament_flow_ratio": [
    "1"
  ],
  "slow_down_min_speed": [
    "10"
  ],
  "slow_down_layer_time": [
    "10"
  ],
  "start_filament_gcode": [
    "; Filament gcode\n"
  ],
  "fan_cooling_layer_time": [
    "60"
  ],
  "close_fan_the_first_x_layers": [
    "3"
  ],
  "hot_plate_temp_initial_layer": [
    "60"
  ],
  "nozzle_temperature_initial_layer": [
    "220"
  ],
  "name": "Jessie PLA @lulzbot",
  "filament_settings_id": [
    "Jessie PLA @lulzbot"
  ],
  "type": "filament"
}