Generic TPU @4Max Pro 2.0

Generic · FLEX · by flsun-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Settings

Basic information

Material variant: FLEX overridden
Vendor: Generic overridden
Diameter (mm): 1.75 overridden
Density (g/cm³): 1.19 overridden

Print temperature

Nozzle (initial layer) (°C): 215 overridden
Nozzle (other layers) (°C): 215 overridden

Cooling

Fan minimum (%): 0 overridden
Fan maximum (%): 0 overridden
Disable fan for first N layers: 3 overridden
Full fan if layer below (sec): 60 overridden
Slow down if layer below (sec): 20 overridden
Min speed when slowed (mm/s): 10 overridden

Flow

Flow ratio: 1 overridden
Max volumetric speed (mm³/s): 1.65 overridden

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	60 overridden	60 overridden

Other settings

bridge fan speed: 0 overridden
compatible printers condition: printer_model=="4MAXPRO20" overridden
cooling: 1 overridden
fan always on: 0 overridden
filament colour: #211AB5 overridden
filament deretract speed: 20 overridden
filament retract speed: 30 overridden
full fan speed layer: 0 overridden

Raw resolved JSON

{
  "cooling": [
    "1"
  ],
  "fan_always_on": [
    "0"
  ],
  "fan_max_speed": [
    "0"
  ],
  "fan_min_speed": [
    "0"
  ],
  "filament_type": [
    "FLEX"
  ],
  "hot_plate_temp": [
    "60"
  ],
  "filament_colour": [
    "#211AB5"
  ],
  "filament_vendor": [
    "Generic"
  ],
  "bridge_fan_speed": [
    "0"
  ],
  "filament_density": [
    "1.19"
  ],
  "filament_diameter": [
    "1.75"
  ],
  "nozzle_temperature": [
    "215"
  ],
  "filament_flow_ratio": [
    "1"
  ],
  "slow_down_min_speed": [
    "10"
  ],
  "full_fan_speed_layer": [
    "0"
  ],
  "slow_down_layer_time": [
    "20"
  ],
  "fan_cooling_layer_time": [
    "60"
  ],
  "filament_retract_speed": [
    "30"
  ],
  "filament_deretract_speed": [
    "20"
  ],
  "close_fan_the_first_x_layers": [
    "3"
  ],
  "hot_plate_temp_initial_layer": [
    "60"
  ],
  "compatible_printers_condition": [
    "printer_model==\"4MAXPRO20\""
  ],
  "filament_max_volumetric_speed": [
    "1.65"
  ],
  "nozzle_temperature_initial_layer": [
    "215"
  ],
  "name": "Generic TPU @4Max Pro 2.0",
  "filament_settings_id": [
    "Generic TPU @4Max Pro 2.0"
  ],
  "type": "filament"
}