common_4max

Unknown · PLA · by flsun-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Inherited from this (1)

*PLA_4max*

Settings

Basic information

Material variant: PLA overridden
Diameter (mm): 1.75 overridden
Density (g/cm³): 1.24 overridden

Print temperature

Nozzle (initial layer) (°C): 210 overridden
Nozzle (other layers) (°C): 205 overridden

Cooling

Fan minimum (%): 80 overridden
Fan maximum (%): 100 overridden
Disable fan for first N layers: 1 overridden
Full fan if layer below (sec): 30 overridden
Slow down if layer below (sec): 15 overridden
Min speed when slowed (mm/s): 10 overridden

Flow

Flow ratio: 1 overridden
Max volumetric speed (mm³/s): 0 overridden

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	60 overridden	60 overridden

Other settings

bridge fan speed: 100 overridden
compatible printers condition: printer_model=="4MAXPRO20" overridden
cooling: 1 overridden
fan always on: 1 overridden
full fan speed layer: 5 overridden

Raw resolved JSON

{
  "cooling": [
    "1"
  ],
  "fan_always_on": [
    "1"
  ],
  "fan_max_speed": [
    "100"
  ],
  "fan_min_speed": [
    "80"
  ],
  "filament_type": [
    "PLA"
  ],
  "hot_plate_temp": [
    "60"
  ],
  "bridge_fan_speed": [
    "100"
  ],
  "filament_density": [
    "1.24"
  ],
  "filament_diameter": [
    "1.75"
  ],
  "nozzle_temperature": [
    "205"
  ],
  "filament_flow_ratio": [
    "1"
  ],
  "slow_down_min_speed": [
    "10"
  ],
  "full_fan_speed_layer": [
    "5"
  ],
  "slow_down_layer_time": [
    "15"
  ],
  "fan_cooling_layer_time": [
    "30"
  ],
  "close_fan_the_first_x_layers": [
    "1"
  ],
  "hot_plate_temp_initial_layer": [
    "60"
  ],
  "compatible_printers_condition": [
    "printer_model==\"4MAXPRO20\""
  ],
  "filament_max_volumetric_speed": [
    "0"
  ],
  "nozzle_temperature_initial_layer": [
    "210"
  ],
  "name": "*common_4max*",
  "filament_settings_id": [
    "*common_4max*"
  ],
  "type": "filament"
}