VOXELPLA PLUS @MEGA

VOXELPLA · OTHER · by flsun-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Inheritance

*common_mega*

→

*PLA_mega*

→

VOXELPLA PLUS @MEGA

Settings

Basic information

Vendor: VOXELPLA overridden
was Generic (inherited)
Density (g/cm³): 1.24 overridden
was 1.24 (inherited)
Cost (/kg): 16.99 overridden
was 25.40 (inherited)

Print temperature

Nozzle (initial layer) (°C): 200 overridden
was 215 (inherited)
Nozzle (other layers) (°C): 200 overridden
was 210 (inherited)

Cooling

Fan minimum (%): 100 inherited
Disable fan for first N layers: 1 inherited
Full fan if layer below (sec): 100 inherited
Slow down if layer below (sec): 20 inherited
Min speed when slowed (mm/s): 15 inherited

Flow

Max volumetric speed (mm³/s): 10 inherited

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	55 overridden was 65	55 overridden was 60

Other settings

compatible printers condition: printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/ inherited
end filament gcode: ; Filament-specific end gcode inherited
fan always on: 1 inherited
filament colour: #FF4640 overridden
was #FF3232 (inherited)

Raw resolved JSON

{
  "fan_always_on": [
    "1"
  ],
  "filament_vendor": [
    "VOXELPLA"
  ],
  "end_filament_gcode": [
    "; Filament-specific end gcode"
  ],
  "slow_down_min_speed": [
    "15"
  ],
  "slow_down_layer_time": [
    "20"
  ],
  "fan_cooling_layer_time": [
    "100"
  ],
  "compatible_printers_condition": [
    "printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/"
  ],
  "fan_min_speed": [
    "100"
  ],
  "filament_cost": [
    "16.99"
  ],
  "hot_plate_temp": [
    "55"
  ],
  "filament_colour": [
    "#FF4640"
  ],
  "filament_density": [
    "1.24"
  ],
  "nozzle_temperature": [
    "200"
  ],
  "close_fan_the_first_x_layers": [
    "1"
  ],
  "hot_plate_temp_initial_layer": [
    "55"
  ],
  "filament_max_volumetric_speed": [
    "10"
  ],
  "nozzle_temperature_initial_layer": [
    "200"
  ],
  "name": "VOXELPLA PLUS @MEGA",
  "filament_settings_id": [
    "VOXELPLA PLUS @MEGA"
  ],
  "type": "filament"
}