Generic PLA @MEGA
Generic · OTHER
· by flsun-system
· 0 downloads
Inheritance
-
*common_mega*
→
*PLA_mega*
→
Generic PLA @MEGA
Settings
Basic information
- Vendor
-
Generic inherited
- Density (g/cm³)
-
1.24 inherited
- Cost (/kg)
-
25.40 inherited
Print temperature
- Nozzle (initial layer) (°C)
-
215 inherited
- Nozzle (other layers) (°C)
-
210 inherited
Cooling
- Fan minimum (%)
-
100 inherited
- Disable fan for first N layers
-
1 inherited
- Full fan if layer below (sec)
-
100 inherited
- Slow down if layer below (sec)
-
20 inherited
- Min speed when slowed (mm/s)
-
15 inherited
Flow
- Max volumetric speed (mm³/s)
-
10 inherited
Bed temperature
| Plate | Initial layer (°C) | Other layers (°C) |
|---|---|---|
| High Temp Plate |
65
inherited
|
60
inherited
|
Other settings
- compatible printers condition
-
printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/ inherited
- end filament gcode
-
; Filament-specific end gcode inherited
- fan always on
-
1 inherited
- filament colour
-
#FF3232 inherited
Raw resolved JSON
{
"fan_always_on": [
"1"
],
"filament_vendor": [
"Generic"
],
"end_filament_gcode": [
"; Filament-specific end gcode"
],
"slow_down_min_speed": [
"15"
],
"slow_down_layer_time": [
"20"
],
"fan_cooling_layer_time": [
"100"
],
"compatible_printers_condition": [
"printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/"
],
"fan_min_speed": [
"100"
],
"filament_cost": [
"25.40"
],
"hot_plate_temp": [
"60"
],
"filament_colour": [
"#FF3232"
],
"filament_density": [
"1.24"
],
"nozzle_temperature": [
"210"
],
"close_fan_the_first_x_layers": [
"1"
],
"hot_plate_temp_initial_layer": [
"65"
],
"filament_max_volumetric_speed": [
"10"
],
"nozzle_temperature_initial_layer": [
"215"
],
"name": "Generic PLA @MEGA",
"filament_settings_id": [
"Generic PLA @MEGA"
],
"type": "filament"
}