*ABSMINI*
Unknown · OTHER
· by super-system
· 0 downloads
Settings
Cooling
- Slow down if layer below (sec)
-
20 overridden
Flow
- Max volumetric speed (mm³/s)
-
10 overridden
Bed temperature
| Plate | Initial layer (°C) | Other layers (°C) |
|---|---|---|
| High Temp Plate |
100
overridden
|
100
overridden
|
Other settings
- compatible printers condition
-
printer_model=="MINI" overridden
- filament deretract speed
-
nil overridden
- filament retract before travel
-
3 overridden
- filament retract length
-
2.7 overridden
- filament retract lift
-
nil overridden
- filament retract speed
-
nil overridden
- filament wipe
-
0 overridden
- start filament gcode
-
M900 K{if nozzle_diameter[0]==0.6}0.12{elsif nozzle_diameter[0]==0.8}0.06{else}0.2{endif} ; Filament gcode overridden
Raw resolved JSON
{
"filament_wipe": [
"0"
],
"hot_plate_temp": [
"100"
],
"slow_down_layer_time": [
"20"
],
"start_filament_gcode": [
"M900 K{if nozzle_diameter[0]==0.6}0.12{elsif nozzle_diameter[0]==0.8}0.06{else}0.2{endif} ; Filament gcode"
],
"filament_retract_lift": [
"nil"
],
"filament_retract_speed": [
"nil"
],
"filament_retract_length": [
"2.7"
],
"filament_deretract_speed": [
"nil"
],
"hot_plate_temp_initial_layer": [
"100"
],
"compatible_printers_condition": [
"printer_model==\"MINI\""
],
"filament_max_volumetric_speed": [
"10"
],
"filament_retract_before_travel": [
"3"
],
"name": "*ABSMINI*",
"filament_settings_id": [
"*ABSMINI*"
],
"type": "filament"
}