Generic FLEX @MEGA

Generic · FLEX · by super-system · 0 downloads

Download for Bambu Studio Download for OrcaSlicer Download for PrusaSlicer

Compare

Inheritance

*common_mega*

→

*FLEX_mega*

→

Generic FLEX @MEGA

Settings

Basic information

Material variant: FLEX inherited
Vendor: Generic inherited
Density (g/cm³): 1.22 inherited
Cost (/kg): 82.00 inherited

Print temperature

Nozzle (initial layer) (°C): 240 inherited
Nozzle (other layers) (°C): 240 inherited

Cooling

Fan minimum (%): 0 inherited
Fan maximum (%): 90 inherited
Full fan if layer below (sec): 100 inherited
Slow down if layer below (sec): 20 inherited
Min speed when slowed (mm/s): 15 inherited

Flow

Flow ratio: 1.15 inherited
Max volumetric speed (mm³/s): 1.2 inherited

Bed temperature

Plate	Initial layer (°C)	Other layers (°C)
High Temp Plate	55 inherited	50 inherited

Other settings

bridge fan speed: 80 inherited
compatible printers condition: printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/ inherited
end filament gcode: ; Filament-specific end gcode inherited
fan always on: 0 inherited
filament colour: #008000 inherited
filament deretract speed: 25 inherited
filament retract length: 0.8 inherited

Raw resolved JSON

{
  "fan_always_on": [
    "0"
  ],
  "filament_colour": [
    "#008000"
  ],
  "filament_vendor": [
    "Generic"
  ],
  "end_filament_gcode": [
    "; Filament-specific end gcode"
  ],
  "slow_down_min_speed": [
    "15"
  ],
  "slow_down_layer_time": [
    "20"
  ],
  "fan_cooling_layer_time": [
    "100"
  ],
  "compatible_printers_condition": [
    "printer_notes=~/.*PRINTER_VENDOR_ANYCUBIC.*/ and printer_notes=~/.*PRINTER_MODEL_I3_MEGA.*/"
  ],
  "fan_max_speed": [
    "90"
  ],
  "fan_min_speed": [
    "0"
  ],
  "filament_cost": [
    "82.00"
  ],
  "filament_type": [
    "FLEX"
  ],
  "hot_plate_temp": [
    "50"
  ],
  "bridge_fan_speed": [
    "80"
  ],
  "filament_density": [
    "1.22"
  ],
  "nozzle_temperature": [
    "240"
  ],
  "filament_flow_ratio": [
    "1.15"
  ],
  "filament_retract_length": [
    "0.8"
  ],
  "filament_deretract_speed": [
    "25"
  ],
  "hot_plate_temp_initial_layer": [
    "55"
  ],
  "filament_max_volumetric_speed": [
    "1.2"
  ],
  "nozzle_temperature_initial_layer": [
    "240"
  ],
  "name": "Generic FLEX @MEGA",
  "filament_settings_id": [
    "Generic FLEX @MEGA"
  ],
  "type": "filament"
}

Version history

View full history with diffs →

v1 created 2026-05-19 13:23